.............................................................................................................................................................................................................................................................
CMF and CRF Series Addressable Control and Relay Modules
Features
- Built-in type identification automatically identifies these devices
to the control panel.
- Internal circuitry and relay powered directly by two-wire SLC loop.
The CMF-300 module requires power (for horns, strobes, etc.).
- Integral LED “blinks” green each time a communication is received
from the control panel and turns on in steady red when activated.
- High noise immunity (EMF/RFI).
- The CMF-300 may be used to switch 24-volt NAC power.
- Wide viewing angle of LED.
- SEMS screws with clamping plates for wiring ease.
- Direct-dial entry of address 01– 159 for MS-9600, 01 – 99
on MS-9200UDLS and MS-9050UD.
Specifications for CMF-300
Normal operating voltage: 15 to 32 VDC.
Maximum SLC current draw: 6.5 mA (LED on).
Average operating current: 350 μA direct poll (CLIP mode), 375 μA
group poll (LiteSpeed mode) with LED flashing.
External supply voltage (between Terminals T3 and T4):
maximum 80 volts (RMS or DC).
Drain on external supply: 2 mA maximum (using internal EOL relay).
EOL resistance: 47K ohms.
Temperature range: 32°F to 120°F (0°C to 49°C).
Humidity range: 10% to 93% non-condensing.
Dimensions: 4.5" (114.3 mm) high x 4" (101.6 mm) wide x 1.25" (31.75
mm) deep. Mounts to a 4" (101.6 mm) square x 2.125" (53.975 mm) deep box.
| 
