.............................................................................................................................................................................................................................................................
MMF-300(A) Series/MDF-300 Addressable Monitor Modules
Features
- Built-in type identification automatically identifies this
device as a monitor module to the control panel.
- Powered directly by two-wire SLC loop. No additional power
required.
- High noise (EMF/RFI) immunity.
- SEMS screws with clamping plates for ease of wiring.
- Direct-dial entry of address: 01 – 159 on LiteSpeed systems,
01 – 99 on CLIP systems.
- LED flashes green during normal operation (this is a
programmable option) and latches on steady red to indicate alarm.
The MMF-300 Monitor Module is intended for use in intelligent, two-wire
systems, where the individual address of each module is selected using the
built-in rotary switches. It provides either a two-wire or four-wire
fault-tolerant Initiating Device Circuit\ (IDC) for normally-open contact
fire alarm and supervisory devices. The module has a panel-controlled LED
indicator.
The MMF-300 can be used to replace M300 modules in existing systems.
| 
